Panel repair · Wichita & Sedgwick County · 67101
Maize is one of the newest parts of our coverage, and it shows in the boards. Modern makes, 200 amp services and current protection mean panel replacement is almost never the answer here. Load questions and construction-stage faults are.
30 min
Typical arrival
67101
Maize zip
200 amp
Typical service in newer builds
Component
Most repairs here, not the board
Nearly every Maize call opens the same way: the house is only a few years old so it cannot be the panel. Often that is right. The cable is fine, the board is fine, and a connection made in a hurry during framing is not.
Among the best we see. Current makes with breakers on the van, 200 amp services in most of the newer subdivisions, arc fault protection on living area circuits and ground fault protection across a wider set of rooms than older housing carries.
That is a genuinely strong starting position, and it means these houses have real headroom for the things people want to add. It also means that when something does go wrong, it is a component and it is cheap to put right.
Usually not, and that is worth hearing from somebody with no reason to say it. Most houses here run a 200 amp service with genuine headroom. We calculate against the existing air conditioning, range, dryer and water heating, apply the demand factors the code allows, and tell you the result.
Where the board takes the charger as it stands, we install the circuit and say nothing further about the panel, because there is nothing further to say.
Around thirty minutes from the yard, with no travel charge inside Sedgwick County. MABCD permits the work from 271 W 3rd St N, Suite 101 on (316) 660-1840. EV circuits, subpanels and new circuits all need one, hot tub wiring needs one every time, and everything is inspected against the 2023 National Electrical Code enforced since January 1, 2025.
Less than in most of our coverage, because the boards are newer and the fault is nearly always a component. A single breaker generally runs $100 to $250 including the visit, and a loose termination found and torqued is typically an hour of labour.
For context, local figures put full panel work in the Wichita area at an average around $1,352 with a typical range of $630 to $2,041. Very few Maize houses end up there, and we would rather say so on the page than have you assume the worst before calling.
Maize sits in northwest Sedgwick County on the growing edge of the Wichita metro.
Reviews
★★★★★
1920s house, fuse box still in service, and an insurer who had finally noticed. They converted it to a modern breaker panel, handled the MABCD permit and the inspection, and gave me a written record I could send straight to the underwriter. No back and forth.
Imani R.Delano
★★★★★
Home inspector flagged double-tapped breakers on our sale. I expected a big number. It was an hour of work and a small invoice, and he re-labelled the whole panel schedule while he was in there without me asking. Sale went through clean.
Doug K.West Wichita
Usually it is not the board itself. What fails at this age is a connection made quickly during construction, most often a lug or a bar termination left finger-tight. It holds for several years, then heat cycling relaxes it and shows up as a warm spot on a thermal reading. It is a cheap fix caught early.
Most houses in Maize already have one, and even where the service is 150 amp there is often room. We run a load calculation against the existing air conditioning, range, dryer and water heating rather than adding up nameplate ratings. Where the board takes the charger as it is, we install the circuit and leave the panel alone.
Because the protection is better. Arc fault and ground fault devices detect conditions an older board would have ignored entirely until something failed. More trips in a newer house is the system watching more closely, not the system being worse. We test the cause rather than removing the device.
No. Maize is inside Sedgwick County and treated as standard coverage, about thirty minutes from our yard. The same-day slot for panels that are hot, humming or giving off a smell applies here on the same terms as inside the city.
Give us the street and the name on the panel door. You will get the next slot running in this area, and a same-day one if the board is hot, humming or giving off any smell.